The rainy season is coming, what should I do if water enters the outdoor led display? In view of the uninterrupted occurrence of such phenomena, the editor will explain the prevention of LED display and the treatment methods of water ingress:
1. It is preventive work. The workmanship of outdoor full-color display screens must be fine when they are installed and waterproofed to avoid water ingress.
2. In heavy rain or heavy rain, the led display should be turned off and suspended.
3. After the rain stops, enter the back of the screen to check for water leakage. In case of water ingress, do not turn on the screen. Use a fan or other tools to completely dry the flooded LED display screen at the fastest speed.
4. The screen body is energized and aged after being completely dried. The specific steps are as follows:
(1) Adjust the brightness (full white) to 10 percent , and aging for 8-12 hours after power on.
(2) Adjust the brightness (full white) to 30 percent , and power on for 12 hours.
(3) Adjust the brightness (full white) to 60 percent , and aging for 12-24 hours after electrification.
(4) Adjust the brightness (full white) to 80 percent , and aging for 12-24 hours after electrifying.
(5) Adjust the brightness (full white) to 100 percent , and aging for 8-12 hours after electrifying.
After the above steps, the water leakage problem of the screen body is basically solved, and the LED display module, power supply, control card and related cables are fully energized to check whether there are problems and hidden dangers. If there are any, replace or repair them immediately, and check the cause of the water leakage of the screen body. , Carry out repairs or repairs to avoid similar situations next time.
